Tag Archives: Buttercream

How To… Piñata Cake and Guinness & Rye Bread

This past week I’ve been doing quite a bit of baking and I’ve been asked to blog the instructions for two of these bakes by several people.  The first, and most popular, is a piñata cake that I made for my niece’s birthday.  The second is an experimental Guinness & rye loaf.  An experiment which turned out much better than I thought it would!

I’ll try and give the instructions in as clear and easy a way as possible but, of course, if there’s any questions just ask.

Piñata Cake

IMG_1772

This is a really easy way to give a sandwich cake a bit of wow factor.  The cake is filled with sweets and when it’s cut the sweets will spill out of the cake.  Hence why it’s called a piñata cake.

I made this with a Victoria Sandwich recipe.  I wanted three layers so I used a standard recipe for two of the layers and then just halved that recipe for the third layer.  I wasn’t sure if that would work but luckily it did.  So here’s the ingredients and method for the sponge part:

Ingredients:

200g soft butter (100g for the 3rd layer)

200g caster sugar (100g for the third layer)

4 eggs (2 for the 3rd layer)

1 tsp vanilla extract (a scant tsp for the 3rd layer)

200g self raising flour (100g for the 3rd layer)

Food colouring gels (optional)

Method:

Set the oven to 190c/375f/Gas Mark 5

Butter and line 3 x 20cm tins

Cream the butter and sugar together until very pale and fluffy.  Add the eggs one at a time, beating after you’ve added each egg.  Stir in the vanilla with a metal spoon.  Sieve in the flour and stir to mix with a metal spoon.  At this point I divided the mix and coloured each layer differently with food colouring gels.  That’s completely optional.  Divide the mixture into the tins and bake for approximately 20 minutes.  Remove from the oven and leave to cool in their tins on a wire rack.  Repeat all the steps for the 3rd layer of sponge.

Now to explain how to assemble and fill the cake.  I used a small amount of seedless raspberry jam to sandwich the layers together.  I used a mixture of Smarties, white chocolate buttons, sweetie teeth and dolly mixtures to fill the cake but to be honest if I was making this again I would use only Smarties as they ‘spill’ out of the cake much easier.  Jelly beans would probably work well too.  At least 5 tubes of Smarties would be needed to fill a cake of this size.

Put the bottom layer of cake on a board with the flat side on the board.  Take a small amount of sponge out of the middle of the cake so you get a slight crater in the cake.  Spread jam round the top of the cake – don’t put any jam on the crater part.  Take the second sponge and cut a circle out of the middle of the cake so your left with a cake ring.  Sit the ring on top of the bottom layer and fill the hole with your sweets, (see pic above.)  Spread jam on top of the ring but make sure it doesn’t drip into the sweets.  Take the third layer.  As you did with the bottom layer, remove a small amount of sponge from the middle of the cake so you’re left with a crater.  If you do this on the rounded side of the cake you’ll be left with a nice flat top for decorating.  Sit the third layer, flat side up, on top of the other two layers.  Press it down gently to make sure all the layers are sticking together nicely, but not so hard that jam comes squirting out of the sides.  Don’t worry if there’s any gaps around the side of the cake as these can easily be filled and smoothed out with your icing.

At this point you could just cover the whole cake with buttercream or cream cheese icing and the effect would still be the same when you cut into the cake.  Because my niece wanted a Peppa Pig cake I was decorating it with fondant icing.  I made a vanilla butter cream and spread a thin layer all over the cake, filling in any gaps around the side of the cake, (see pic above.)  I then put it in the fridge until the buttercream set.  This stops crumbs from the cake getting into your icing.  I then removed it from the fridge and applied a second coat of buttercream which was the glue for the fondant icing which was rolled out, draped over the cake and cut and smoothed to a neat-ish finish, (see pic above.)  I then decorated the cake with a fondant icing Peppa Pig, fondant stars and my niece’s name iced onto the cake.

Any decoration would work well with this cake whether it’s a creamy icing or a fondant or royal icing.  There’s no way of telling from the outside of the cake that there’s loads of sweeties inside so the look on face of the person you’ve baked it for when then they cut into it will be worth the little bit of extra work you’ve put into making the cake.  I promise, this is not much more difficult that baking and assembling a standard sandwich cake.  You’re just making one extra layer and doing a wee bit of cutting.  If you don’t want to waste the extra sponge you’ve cut out you could maybe use it to make cake pops or just eat it as you go along!

Guinness & Rye Bread

IMG_1792

I hadn’t baked any bread for a while and fancied having a bit of an experiment with a new loaf.  As I had some Guinness in the house and some rye flour that never gets used I thought I would try using them in the loaf.  The recipe was based on a tin loaf recipe with a few tweaks.  Tweaking doesn’t always work in baking as it’s such a science but sometimes it’s good to try something new.  If it works, great.  If not, it’s all a learning experience.  I’m glad to say this particular experiment worked.

Ingredients:

300g strong bread flour

100g rye flour

8g table salt

7g instant yeast

25g unsalted butter, melted,

250ml Guinness

oil for kneading and greasing the tin

Method:

Put the flour, salt and yeast in a large bowl.  Make sure the salt and yeast don’t touch at this stage as the salt will kill the yeast.

Add the butter and about 2/3 of the Guinness and turn the mixture around with your fingers to make a dough, (if your hand looks like a claw you’re doing it right!)  Slowly add the rest of the Guinness whilst mixing until all the flour has been picked up into a dough.  You might not need to use all the liquid or you might need a bit more, (the Guinness comes in 330ml bottles so you’ll have plenty.)  Keep mixing in the bowl until you have a rough dough.

Spread a little bit of oil on your work surface to stop the dough sticking.  Put the dough on the work surface and then knead for a good 10 minutes until the dough feels smooth and not sticky.

Put the dough into an oiled bowl, cover with a tea towel and leave somewhere warm for at least an hour until the dough has doubled in size.

Oil a 1kg loaf tin.

Tip the dough onto a work surface that’s been lightly floured.  Shape the dough into a ball until all the air is knocked out and you have a smooth dough.  Roughly shape it into an oblong to fit the tin making sure that any folds are on the bottom.  Put the dough into the oiled tin.

Put the tin into a plastic bag and leave it somewhere warm for at least an hour until the dough has doubled in size.  It should spring back when you prod it gently.  Set the oven to 220c and put a roasting tin in the bottom of the oven.

Dust the top of the loaf with a wee bit of flour.  Fill the roasting tin with some water to create steam, which will give you a nice crust, and put the bread into the oven.

Bake for around 30 minutes.  You’ll know the bread is ready when you take it out of the tin and you tap the bottom and it sounds hollow.

Cool the bread, out of the tin, on a wire rack.

The flavour of this bread was yeasty and nutty.  The smell when it was baking was fantastic and the Guinness and rye flour gave it a lovely colour.  This was great just with butter but would also be perfect with cheese.  Given it’s ale content it would be the ideal loaf to have with a Ploughman’s.  Delicious.

Tagged , ,
%d bloggers like this: